It hasn't been since March of 2014 that I took and passed my multi-engine commercial check-ride. This was the last time I've flown the multi; the multi being a Beechcraft Travel Air 95.
On October 30th,in Wichita Kansas, a King Air crashed into building shortly after takeoff after purportedly losing engine power in one engine. The NTSB investigation is on-going and I won't even venture to guess as to what might have went wrong. The procedure outlined in this post I know is for sure only applicable to light-twins and I am not familiar with procedures in the likes of a King Air or larger twin. My thoughts are with the everyone impacted by this tragedy. This incident however has taken me right back to March and my multi-engine flight training.
Fundamentally, the core of the multi-engine training relies heavily on the memorization and application of the eight point check-list. It's a series of actions that is repeated until it becomes second-nature not dissimilar to many other things learned in aviation.
Bang, bam, boom.....ENGINE FAILURE....
Mixture (both controls full forward)
Prop (both controls full forward)
Throttle (both controls full forward)
Flaps-up (if extended)
Gear-up (gear up if extended)
Dead-foot/dead engine, identify, verify
Feather
Mixture
....in that sequence.
Simply, the point of these steps is two-fold; to achieve maximum power on the good engine while decreasing drag (feathering) on the bad engine. In the case of a single engine failure, power is cut by 50% but performance can decrease as much as 80-90%.* Accounting for a considerable amount of the performance loss, drag increases drastically on the failed engine. Drag is simply defined as a retarding force that acts opposite to the direction of flight. A wind-milling or stopped propeller blade perpendicular to the oncoming air has the same effect as holding a piece of plywood out of the window while driving down the freeway at 100mph in your car.
The items again in greater detail:
Mixture - Both mixture controls full forward. Fuel economy is of little concern at this point when maximum power is the goal in an emergency. You are not 100% sure of which engine has failed
Prop - Both prop controls are pushed forward to command flat pitch from the propellers so as to achieve the greatest RPM once power is added. Again, you are not sure which engine has failed so push them both up.
Throttle - Bother throttles are pushed forward to gain maximum thrust from the good engine.
Flaps - If flaps are extended, they are now retracted to reduce drag.
Gear - The landing gear, if extended is retracted to again, reduce drag.
Dead-foot/Dead engine, Identify, Verify - With a sudden loss of power, asymmetrical thrust will cause the airplane to yaw towards the dead engine. Force will need to be applied in the opposite direction to the yaw. For example, the right engine fails and immediately the left rudder pedal requires considerable pressure to maintain directional control of the airplane; the right foot is a limp noodle. This is almost automatic for the pilot, hence the term "dead foot". The pilot will identify the correct engine failed by identifying the proper throttle and slowly retarding the throttle to confirm before reducing the throttle to idle completely. Should you you begin to retard the throttle and note a power loss, you've identified the wrong engine and don't want to reduce your thrust in the good engine.
Feather - The propeller control will be moved to the feather detent after the throttle is brought to idle on the failed engine.
Mixture - The fuel supply to the failed engine will be cut off as the mixture control is moved to the cut-off position.
Drag has now been mitigated and now the pilot can reference the checklist and trouble shoot the engine, time permitting.
In the multi-engine coarse the flight instructor will demonstrate a "drag demo" by retarding an engine to simulate a non-feathered, failed engine, with flaps and gear extended. The penalties can be as severe as follows:
Windmilling propeller - 350 ft/min
Landing gear extended - 150 ft/min
Flaps fully extended - 200 ft/min
That is potentially a 700 ft/min loss in performance for the BE95 and probably similar to the penalties in other light twins. Needless to say, these steps are practiced continually and relied upon heavily by any light multi-engine pilot should the day come that he or she feels that foot go dead. If accomplished successfully, the pilot might be in a position to make a successful landing at a suitable airport, or at least increases his or her odds of a survivable outcome.
No comments:
Post a Comment